[zenoss-users] A couple of questions

[James Alspach]

I am running Zenoss Stack V 2.2.3  It was running great for a week or
so, until yesterday.  Yesterday I added 31 locations (most of which have
no equipment in them yet) and 2 Zenpacks (the Dell monitor and the NTP
monitor).  This was up until probably 5pm or so.  Last night about 6:15
(after everyone had gone home) the graphs stopped.  I came in this
morning to find the Zenoss issues portal filled.  

I restarted Zenoss and an hour and 20 min later, the graphs died again.
I removed the ntp Zenpack, to no avail. 

It seems that, about an hour after Zenoss starts up, I loose the
heartbeat for Zenmodeler, followed in about 10 min with zentrap, status,
syslog, ping, win, eventlog, and command.  About 10 min after command
goes down, snmp and actions fail. 

I do a /init.d/Zenoss-stack stop followed by a start and everything is
good again for an hour or so before the stuff hits the fan again.

 

Any Suggestions?

 

My second question I asked the other day but, since I am posting again I
thought I would ask it again. Is there a way to set a priority on a
class?  I would like Workstations, Printers and Discovered to have a
lower priority.  I can do this manually but I thought applying it to the
class would be the most straight forward way.

 

Thanks;

James

 

 

 

 

James Alspach
Systems Analyst II

Shasta County Office of Education

1644 Magnolia avenue

Redding, California

96003
jalspach at shastacoe.org <mailto:jalspach at shastacoe.org> 
(530) 225-0293

 

IT Hotline: 225-0279

hotline at shastacoe.org <mailto:hotline at shastacoe.org> 

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.zenoss.org/pipermail/zenoss-users/attachments/20080731/164a17b8/attachment-0001.html